Cars like women need to be protected, but maintenance also needs to pay attention to time and secrets. When our car goes 15,000 kilometers, besides completing 2500 kilometers and 7,500 kilometers car maintenance and protection projects, in fact, we should also check the following items.

　　part 1

　　Part 1

　　查看照明灯、报警灯、转向灯和轿车喇叭的功能，查看前大灯灯光的位置,必要时进 行调整；

　　Check the functions of lighting, alarm lights, turning lights and car horns, check the location of headlights and adjust them when necessary.

　　查看风窗雨刮器和清洗设备的功能,必要时添加清洗液；

　　Check the function of windshield wiper and cleaning equipment, and add cleaning liquid if necessary.

　　查看手动变速器车型的离合器踏板行程，必要时进行调整；

　　Check the clutch pedal travel of the manual transmission model and adjust it if necessary.

　　查看后轮毂轴承空隙及油脂的光滑情况，必要时进行调整；

　　Check back hub bearing clearance and grease smoothness, adjust if necessary;

　　查看火花塞情况,必要时替换新件。

　　Check the spark plug and replace it if necessary.

　　part 2

　　Part 2

　　清洗空气滤清器外壳，替换滤芯；

　　Clean the shell of the air filter and replace the filter element.

　　光滑门、盖铰链以及门拉带，在车门限制器上涂敷光滑脂；

　　Smooth doors, cover hinges and door bands are coated with smooth grease on the door limiter.

　　查看带是否完好无损；

　　Check if the seat belt is in good condition.

　　查看排气设备有无损坏现象；

　　Check whether the exhaust equipment is damaged or not.

　　查看门把手,必要时修理车门锁；

　　Check the door handle and repair the car door lock if necessary.

　　查看怠速情况和怠速时的一氧化碳含量，必要时予以调整；

　　Check idle conditions and carbon monoxide content at idle speed and adjust it if necessary.

　　查看转向横拉杆接头空隙、固定程度和防尘罩的密封性。

　　Check the joint clearance of steering tie rod, the degree of fixity and the sealing of dust shield.

　　part 3

　　Part 3

　　查看轮胎斑纹深度，并做好记载;查看轮胎气压,必要时进行充气;查看轮胎固定螺 栓力矩，必要时按规则力矩拧紧；

　　Check the tire speckle depth and make a good record; check the tire pressure, inflate if necessary; check the fixed bolt moment of the tire, tighten according to the regular moment when necessary;

　　查看焚烧提早角，必要时进行调整；

　　Check the incineration early angle and adjust it if necessary.

　　查看驻车制动器,必要时进行调整；

　　Check the parking brake and adjust it if necessary.

　　查看球头销松紧度及防尘罩密封性，查看防抱死制动体系的故障诊断接口；

　　Check the tightness of ball pin and the sealing of dust cover, and check the fault diagnosis interface of anti-lock braking system.

　　查看前、后制动器摩擦片的厚度。

　　Check the thickness of front and rear brake friction pads.

　　试车查看：

　　Trial run:

　　查看车辆制动体系、驻车制动器、变速器、转向操纵组织、转向器、转向传动组织和空调的工作情况。

　　Check the working conditions of vehicle brake system, parking brake, transmission, steering control organization, steering gear, steering transmission organization and air conditioning.

　　查看前、后车架和车身连接的橡胶件、橡胶轴承、左右控制臂铰链和车架上的橡胶件是否老化变形。

　　Check whether the rubber parts, rubber bearings, left and right control arm hinges and rubber parts on the frame are aged and deformed.

　　看完后是否理解了，为何每次进场维保，都是一大堆技师忙前忙后，还要等老半天。其实每位技师都是想把每台车在手上变得更好，把一切危险都排除掉！

　　After seeing whether understand, why each entry maintenance, is a lot of technicians busy before and after, but also waiting for a long time. In fact, every technician wants to make every car better in hand and eliminate all dangers!