Under normal operation condition, the clutch is tightly engaged and there is no "slip" phenomenon. But the automobile clutch is a part of the automobile with frequent friction. With the increase of using time, the clutch is more likely to slip. If the driver does not know the front wheel of the clutch slip, when the clutch slips, the automobile cannot start. It is important to note that the replacement of the clutch plate must be carried out in the repair shop and the driver cannot repair it himself. Is there any way to predict clutch slip?

　　想想，有以下情况，离合器可能已经出了故障:

　　Consider that the clutch may have failed:

　　1.在标准条件下，车辆不能达到速度。

　　1. Under standard conditions, the vehicle cannot reach the maximum speed.

　　2.在快速加速的情况下，发动机转速迅速提高，而车辆加速滞后，加速下降。

　　2. In the case of rapid acceleration, the engine speed increases rapidly, while the vehicle acceleration lags behind and the acceleration decreases.

　　3.长时间行驶在山路上，车辆会有一种很明显的异味。

　　3. When driving on the mountain road for a long time, the vehicle will have a very obvious peculiar smell.

　　当车辆开始松开离合器踏板时，应将离合器举得很高。

　　When the vehicle begins to release the clutch pedal, raise the clutch very high.

　　如果汽车出现上述情况，很可能是滑动离合器的故障。一个简单而有效的方法确定离合器滑动现象:定期启动引擎,放在个齿轮,不释放拉手闸,慢慢抬起离合器,直到所有电梯,如果车辆立即关闭汽车将证明汽车的离合器没有滑动的问题,相反,应该修理汽车的离合器。

　　If the car has the above situation, it is likely to be the fault of the slip clutch. A simple and effective method to determine the clutch sliding phenomenon: start the engine regularly, put it on the first gear, do not release the handle brake, slowly lift the clutch until all elevators, if the vehicle closes the car immediately, it will prove that the clutch of the car does not slide. On the contrary, the clutch of the car should be repaired.

　　那么，如何防止汽车离合器打滑呢?

　　So, how to prevent the clutch from slipping?

　　正确使用离合器是防止离合器过早打滑的关键。在学习开车的时候，许多教练提醒他们的学生不要一直踩着离合器，但是很多人无法改变这个习惯。但长期将脚放在离合器上会造成离合器半联动，使离合器一直处于摩擦状态，其结果会引起离合器盘烧蚀，甚会使离合器压盘和飞轮烧蚀，造成离合器俗称“打滑”。同时也会导致燃油的成本上升，增加汽车的成本。

　　Correct use of the clutch is the key to prevent the clutch from slipping too early. When learning to drive, many coaches remind their students not to step on the clutch all the time, but many people cannot change this habit. However, if the foot is placed on the clutch for a long time, it will cause the clutch to be semi linked and keep the clutch in a friction state. As a result, it will cause the erosion of the clutch disc and even the erosion of the clutch pressure plate and flywheel, resulting in the clutch commonly known as "slipping". At the same time, it will increase the cost of fuel and increase the cost of cars.

　　因此，除了起动、换挡和低速制动需要踩紧离合器踏板，不要没有东西踩紧离合器，或者把脚放在离合器踏板上。同时，还必须掌握正确使用离合器的技巧。正确操作开始:轻轻抬起离合器踏板,离合器semi-linkage出现时,发动机声音变得沉重,慢慢拿起离合器踏板,离合器踏板抬起的同时,根据发动机阻力的大小逐渐按下油门踏板,使汽车平稳起步。换挡时正确操作:在交通中换挡时，离合器踏板的操作应迅速，不要出现半联动现象，否则会加速离合器片的磨损。此外，操作时要注意配合油门，不要一边踩油门一边踩离合器踏板。

　　Therefore, in addition to starting, shifting and low-speed braking, it is necessary to step on the clutch pedal. Do not step on the clutch without anything, or put your foot on the clutch pedal. At the same time, we must master the skills of using the clutch correctly. Correct operation start: gently lift the clutch pedal, when the clutch semi linkage appears, the engine sound becomes heavy, slowly pick up the clutch pedal, while lifting the clutch pedal, gradually press the accelerator pedal according to the size of the engine resistance, so as to make the car start smoothly. Correct operation during shifting: when shifting in traffic, the operation of clutch pedal shall be rapid, without semi linkage, otherwise the wear of clutch plate will be accelerated. In addition, pay attention to cooperate with the accelerator during operation, and do not step on the clutch pedal while stepping on the accelerator.

　　以上是济南奥迪汽车维修公司小编为大家介绍的相关内容，想要了解更多内容，欢迎访问网站：http://www.lutongqixiu.com

　　These are the relevant contents introduced by Jinan Audi automobile maintenance company. If you want to know more, please visit the website: http://www.lutongqixiu.com