Replacement of spare tires is certainly not a simple job for beginners, and for many old drivers, they are unlikely to meet either! Sometimes on the road, if there is a tire problem and there is no repair shop nearby, Ben taught us the correct way to change tires today!

　　准备过程

　　Preparation process

　　首要你要准备几样东西，备胎、三角牌、螺丝扳手、千斤顶!

　　First of all, you have to prepare several things, spare tires, triangle cards, screw wrenches, jacks!

　　三角牌的作用就不用说了，在换备胎时，放置在车后 50-100 米，高速上要 150 米，确保。剩下的就都是换胎用的东西了!注意，车要停好!尽或许排除隐患!

　　The role of the triangle is needless to say, in the replacement of spare tires, placed in the rear of the car 50-100 meters, 150 meters on the high-speed, to ensure safety. All that's left is for tire replacement! Pay attention, the car should stop well! Perhaps eliminate the potential safety hazards! uuuuuuuuuu

　　拆卸破损轮胎

　　Remove damaged tyres

　　别一上来就把千斤顶先弄上，必定先要用螺丝扳手送送螺丝(是拧松，不是卸下!)，注意，在松螺丝的时候，要采取对角线逐个拧松的办法，由于这样才不会使得螺丝、轮胎、轮毂变型!

　　Don't put the jack on first, you must send the screw with the screw wrench (it's loosening, not unloading!). Note that when loosening the screw, we should take the diagonal loosening method one by one, because this will not make the screw, tire, hub variant!

　　注：一般来说，逆时针是拧松螺丝，顺时针是拧紧!螺丝一般比较紧，稍加用力才干松开，切记!

　　Note: Generally speaking, counterclockwise is to loosen the screw, clockwise is to tighten! The screw is generally tighter, slightly more effort to loosen, remember!

　　下一步就要使用千斤顶了!千斤顶都是有支撑方位的，一般在车辆中部下方，车辆都会有标示!一般间隔轮胎 10-15 分!如下图所示!

　　The next step is to use the jack! The jacks are all bearing, usually in the middle of the car below, the vehicle will be marked! Tyre interval is generally 10-15! As shown in the following figure!

　　升起车身时，速度不宜过快，防止出现滑落等情况!车身不宜升起过高，能拆卸轮胎即可，过高了反而会给装置等造成欠好的影响!

　　When lifting the body, the speed should not be too fast to prevent sliding and other situations! The body should not be raised too high, can dismantle the tires, too high will cause bad effects on the device, etc.

　　装置备胎

　　Spare parts

　　装置备胎时，困难的一步就是如何将备胎与螺丝孔对齐、固定!告诉我们一个好办法，用手或者脚抵住轮胎，或许会好一点!别的，不要一上来就把螺丝全部拧死，必定等全部承认没有问题，终在紧螺丝!

　　When installing spare tires, the most difficult step is how to align and fix spare tires with screw holes! Tell us a good way to put your hands or feet against the tires, maybe better! Otherwise, don't screw all the screw up, it must be acknowledged that there is no problem, and finally tighten the screw!

　　备胎只能解当务之急，不能长期使用，必定要先开到修理厂，将轮胎弄好!否则会有后患!行驶过程中，轮胎是非常重要的一环，我们需谨慎啊!

　　The spare tire can only solve the urgent matter, and can not be used for a long time. We must go to the repair shop first to get the tire well. Otherwise, there will be aftermath. In the course of driving, the tire is a very important part, and we need to be careful!