一些初驾车或初学
济南奔驰汽车维修的人员，可能会认为所有零配件都需要清洗，其实这种认识是片面的。对于发动机的纸质空气滤芯，在清除其上的尘土时，就不能用任何油类清洗，只需用手轻轻拍击或高压空气由滤芯内向外吹通即可;对于皮质零部件，也不宜用油类清洗，只需用干净的抹布擦干净即可。
Some people who are new to driving or learning to repair Jinan Benz cars may think that all parts and components need to be cleaned. In fact, this understanding is one-sided. For the paper air filter element of the engine, when removing the dust on it, you can't use any oil to clean it, just tap it with your hand or blow high-pressure air from the inside to the outside of the filter element; For leather parts, it is not suitable to clean them with oil, just wipe them with clean rags.
轮胎外胎如果长期堆压存放且不及时翻动，就会因挤压而发生变形，影响使用寿命;空气滤清器、燃油滤清器的纸质滤芯，如发生挤压，会产生较大的变形而不能可靠的起到滤清作用;橡胶油封、三角胶带、油管等也不能挤压，否则同样会发生变形，影响正常使用。
If the outer tire of the tire is piled up and stored for a long time and does not turn over in time, it will be deformed due to extrusion, affecting its service life; If the paper filter element of air filter and fuel filter is squeezed, it will produce large deformation and cannot reliably filter; Rubber oil seal, triangular tape, oil pipe, etc. shall not be squeezed, otherwise it will also deform and affect normal use.
轮胎、三角胶带、缸套阻水圈、橡胶油封等橡胶制品，如果靠近火源，将容易老化变质或损坏，另一方面还可能引起火灾事故。尤其是一些柴油汽车，冬季严寒难以启动，一些驾驶员常用喷灯加热，一定要防止烧坏线路、油路等。
Rubber products such as tires, triangular tape, cylinder liner water stop, rubber oil seals, etc., which are close to the fire source, will easily age, deteriorate or be damaged, and on the other hand, may cause fire accidents. Especially for some diesel vehicles, it is difficult to start in the cold winter. Some drivers often use blowtorch to heat, so they must prevent burning the lines and oil lines.
有些零件本应一次性使用，个别驾驶员或修理工却为了节约或因不了解“禁忌”而重复使用，这样易导致事故的发生。一般来说，发动机连杆螺栓、螺母、进口柴油机喷油器固定螺栓、缸套阻水圈、密封铜垫、液压系统的各类油封、密封圈以及重要部位的销片、开口销等零件拆卸后，须更换新品。
Some parts should be used once, but some drivers or repairmen reuse them in order to save or do not understand the "taboo", which may lead to accidents. Generally speaking, the engine connecting rod bolts, nuts, fixing bolts of imported diesel engine fuel injectors, cylinder liner water stop rings, sealing copper gaskets, various oil seals and sealing rings of the hydraulic system, as well as the pins and cotter pins in important parts, must be replaced with new ones after disassembly.
For the engine cylinder gasket, although no damage is found during maintenance, it is also good to replace the new one, because the old one has poor elasticity, poor sealing, and is easy to be damaged by ablation, and needs to be replaced after a short time of use, which is time-consuming and laborious. Therefore, if there is a new one, it is better to replace it as much as possible. Come to our website for more relevant auto content http://www.lutongqixiu.com Ask!
